Concrete floor installation in Yuma AZ - a slab ready for tile, wood or carpet
Need a new concrete floor for an addition, shop or room? We dig out the base, pour and cure a slab ready for your flooring.
Concrete floor installation is ground work first. The slab comes after.
Concrete floor installation in Yuma means pouring a slab on grade, a floor laid right on the ground, for a shop, an addition or a new room. Later it can carry carpet, tile or wood, so what goes under the slab matters as much as the top you see.
Most calls are for a new room or shop that needs a floor, or an old one that's cracked, sunk at one end or popping its tile. Concrete is hard to undo, so the ground has to be right. If the job runs outside too, like concrete steps or a concrete pool deck, I'll look at it on the same visit.
Price moves with the floor's size, its thickness, whether it needs steel, how much digging the ground takes and what goes under the slab. The schedule turns on the permit, the city's inspections and the heat. When I come out, my written estimate puts your own numbers on all of it.
Your flooring comes first. We plan the concrete floor installation around it.
Tell me before the pour if the floor will get tile, wood or carpet, or if you'll keep anything on it that can't take damp. A vapor retarder, a sheet laid under the slab, is what keeps ground moisture from coming up through it, and once the concrete is down there's no adding one.
Wind, low humidity and hard sun can dry fresh concrete fast and make it set early, and national guidance says that happens most in dry climates like ours. So we time pours around the hottest part of the day when we can, and I'll tell you when to expect us.
Concrete floor installation covers more than the pour. Here's the whole job.
Ground check and layout
I walk the space, look at the ground and mark where the floor sits, so the forms go in square and at the height you need.
Digging out the base
The subgrade, the ground the slab sits on, gets dug out and packed firm, because a floor only stays flat if what's under it does.
Steel in the slab
When a floor calls for it, we set rebar, steel bars inside the slab that hold the concrete together as it moves and keep cracks from spreading.
Placing and finishing
We place the concrete and trowel it smooth and flat, so it's ready to take flooring or serve as the finished floor itself.
Control joints
Control joints are shallow cuts that give the slab a place to crack on purpose, and we cut them on time so cracks are more likely to follow the lines.
Curing the slab
Curing is the wait while concrete gains strength, and we keep the slab from drying out too fast so the top stays hard instead of dusty.
Good ground work pays off. Concrete floors and slabs show it for years.
Most floor trouble starts under the concrete. A base that's raked level instead of dug out and packed settles with the dirt, and the floor drops with it. Joints cut late or skipped let the slab crack wherever it wants, and a top that dries too fast turns weak and dusty.
When budgets get tight, the base is the first thing people want to trim, because nobody sees it on day one. I'd trim the finish first, since a plain floor on packed ground holds up better than a fancy one on loose dirt. I'd also rather take a second look at the ground than rush a pour.
From your first call to the walk-through. Here's how it goes.
Call or send a message
Call (928) 291-0009 or use the form, tell us the floor size and what's going on top, and we'll get back to you.
I come out myself
I look over the site and the ground, and ask how you'll use the floor and what flooring you plan to lay on it.
Your written estimate
You get a written estimate that's easy to read. Once you say yes, I check what the job needs with the building office and handle any permit and inspections.
The pour and clean-up
The city inspects before the base is covered and asks for about a day to respond, so we plan for it. Then our crew pours, finishes, cleans up, and I walk the floor with you.
Tell us about your floor. We'll come take a look.
Send the floor size, the flooring you plan and whether you're inside Yuma city limits. We reply within one business day to set up a free, no-obligation estimate visit.
(928) 291-0009We're based in Yuma. We work across the cities around it.
We're based in Yuma and pour floors across the cities around it, including Fortuna Foothills and Somerton. If your city isn't listed here, call and ask.
Mon–Fri: 7 AM–10 PM, Sat–Sun: 6 AM–11 PM
Concrete floors raise fair questions. Here are straight answers.
Read through the answers below, and if your question isn't here, call (928) 291-0009 and ask me directly.
How much does a concrete floor cost in Yuma, AZ?
A concrete slab in Yuma usually costs about $6 to $12 per square foot before any staining or stamping, and that's slab pricing in general, not interior floors alone. A reinforced slab runs higher per square foot than a plain pad. Your written estimate gives your own figure.
Do I need a permit for a concrete floor in Yuma?
Usually yes, because the City of Yuma generally requires a permit and inspection for any new construction or remodel, and its Building Safety Division helps with permit steps. Before we set a date, I check what your job needs, and when a permit is needed we apply and schedule the inspections.
Does a contractor need a license to pour a floor in Arizona?
For a job that needs a permit, yes. As Arizona's law reads, only casual or minor work under $1,000 can skip a contractor's license, and that exemption doesn't cover work that needs a local building permit. We're licensed and insured.
Will my new concrete floor crack?
Some cracking and curl, the edges lifting a little as it dries, is normal, because floor guidance says no new floor is completely free of either, even when it's built right. Problem soils across Arizona, Yuma included, can also heave and crack slabs, so we check the ground, pack the base and cut joints on time to keep it down.
How long does new concrete need to cure in hot weather?
Hot-weather guidance says curing should start as soon as finishing ends and go on for at least 3 days. Crews can cover the slab with wet burlap and plastic, spray on a curing compound or keep it wet with water, and I'll tell you which we're using on your floor.
There's more we can pour. See our other concrete services.
- Concrete driveway building
- Concrete patio construction
- Stamped concrete services
- Concrete sidewalk building
- Garage floor concrete
- Decorative concrete
- Concrete retaining walls
- Concrete pool decks
- Concrete steps construction
- Slab foundation building
- Foundation installation
- Concrete parking lot building
- Concrete footings
- Foundation raising
- Concrete cutting
Need a concrete floor or slab? Call for a free estimate.
Tell us the floor size and what's going on top, and I'll set a time to come look before you've bought any flooring.
(928) 291-0009